8 Way relay with binary and I2C interface
Multi-Interface 8 Way relay BV4627-B
This device contains 8 single pole double throw (SPDT) relays that can be
operated in two ways. The actual attached relays are capable of switching up to
10A @24V DC and 10A @250V AC. Each relay can be instantly switched on or off or
commanded to switch at a set time of up to 1.3 hours (I2C only).
- Normally open 10A @ 250V
- AC Normally Closed 6A @ 250V AC
- 10A 24V DC
There are two versions of this board. The full version and a cut down version
that does not have the IR and USB interface. This data sheet describes the full
version, if you have the cut down version then ignore the IR and USB sections.
*This item is for the CUT DOWN version without USB and IR
interface and so has TWO interface options
Data sheet and resources
- 8 relays 10A contact rating
- Binary interface
- I2C interface
- USB interface
- Infra Red Interface
- Delayed on/of timer*
- Momentary or toggle switch action**
- Voltage 5V***
- Current 1.5mA (all relays off)
- Size 83mmx80mmx18mm
* Feature available on USB & I2C interfaces only ** Feature available on IR
interface only *** Each relay when on consumes approximately 80mA
The following describes each of the interfaces that are available. The
interfaces are mutually exclusive, that is only one interface can be used at a
time. The selection of the interface is automatic and depends on what is
connected to the device.
The Binary Interface
This is intended for simple interfacing to electronic equipment that could be
discrete logic or a microcontroller. Three lines select the relay and one line
is used as a clock to switch the relay on or off. A short clock pulse switches
the selected relay off and a long clock pulse switches it on.
The I2C Interface
This is designed for connection to a microcontroller or similar device. The
device has an address of 0x64 but that can be changed in software by the user.
The interface works by issuing commands to the device to switch the relays on
and off. A particular feature of this interface is that the switching (on or
off) can be delayed for up to about an hour. This can be useful for reducing the
resources required on the host system or even switching the host off altogether
after a certain period.
The USB Interface - Full version only
This interface is designed for connection to a PC. It
uses the FTDI chip to create a virtual COM port which had drivers available for
most operating systems. Once the COM port is established the communication and
operation is carried out by simple text commands. It is very simple to create a
VB or other program to send text commands to operate the relays. This also has
timed switching so it would even be possible to send a timed off command to the
host PC, have the PC carry out and orderly shout down and the relay could
completely power off the PC after a minute or so.
The IR Interface - Full Version only
The device has an Infra Red receiver that is tuned to
the average remote control (36KHz). The USB interface is used to set up the
control and the user selects the keys that will operate the required relay. The
keys can select a toggle action (press once for on and once for off) or a
momentary action where the relay is on whilst the key is pressed. This could be
mapped to the volume control for example and one relay would come on at +V
and the other relay would come on at -V - possibly opening and closing curtains
The interface can be set up for a variety of remote
handsets and the actual information received does not have to be exact just as
long as a different value is received for a different remote key press. Once set
up the device will operate independently, all it needs is a 5V power supply.
What you get
This is for the CUT DOWN version BV4627-B with 2 interfaces.
There is also available as the full version with the USB and IR interfaces.